Eteima Mathu Naba Story High Quality Verified Extra Quality Instant

Calculate values such as rolling circumference differences, speed deviations, changes in ground clearance, tire diameter, rim width, track width changes or the use of spacers for adjusting the offset (ET calculator) and find out which tires or wheels are best suited for your vehicle. You will also receive a helpful graphical representation.

Eteima Mathu Naba Story High Quality Verified Extra Quality Instant

Results

Existing

Desired

Tire circumference

Rolling circumference

Tire height (sidewall)

Tire diameter

Rim size

Rim width

Poke (Outer Edge)

Inset (Inner Edge)

Show results in

mm cm in ft

Comparison & differences

Difference in rolling circumference

Speedometer display at real 100 mph or km/h

Speedometer at 100 km/h or mph

The following differences also arise:

Difference in ground clearance

Change to the outer edge of the rim per side

Change to the inner edge of the rim per side

Graphic display appears after entering values

The strut illustration is for illustrative purposes only

2: Read the result

Note the difference in rolling circumference:

Rolling circumferences are generally approved in the range +1.5% und -2.5% g. Please check with the responsible inspector beforehand.

Speed deviation outside the norm:

In EU countries, the speedometer may display a maximum of +10 % + 4 km/h and no km/h less than the actual speed driven.
See regulation No 39 of the Economic Commission for Europe of the United Nations (UN/ECE): Point 5.4

Share your calculations

Send by e-mail

Print calculations

No guarantee is given for the correctness of the information and data calculated by the tire calculator / ET calculator / rolling circumference calculator / rim calculator. Any liability based on the data and information calculated here (ground clearance, rolling circumference, tire diameter, rim width, offset (ET), ...) is expressly excluded. The type of tire, wheel load, air pressure and tread wear as well as manufacturer and design-specific deviations have a slight effect on the actual values.

Feedback